On this video, we stroll you thru how you can shingle a roof so it’s straight and water tight. the These undertaking tips are for low roofs that enable quick access, resembling these on porches, sheds, or doghouses. For bigger roofs, hiring knowledgeable roofing crew with correct fall safety is suggested.
How Laborious is it to Shingle a Roof?
Including shingles on to a roof will be difficult and harmful. It’s necessary to put on the suitable security gear resembling harness and a line connected to the ridge or a staging with security rails round it to guard your self from falling.
Ought to Shingles Overhang the Drip Edge?
Overhanging shingles over the drip edge a couple of half inch might help with floor pressure. Plan out how you’ll lay your shingles beforehand, right here’s how we advocate you method your set up.
Putting in Roof Shingles in 11 Steps:
- To start out putting in shingles, line up aluminum drip edge flush with the sting of the roof and make a pencil line on the prime on every finish of the home.
- Utilizing the chalk line, snap a line between the 2 marks to get a straight edge.
- Pull the drip edge down a couple of half-inch from that line to create a niche between the drip edge and the fascia board.
- Nail the drip edge in place utilizing 1¼-inch galvanized roofing nails and a hammer.
- Repeat steps for gabled ends, putting in the drip edge up the roof alongside the gable.
- Lay out 30-lb. asphalt roofing felt paper and nail it in place utilizing 1¼-inch galvanized roofing nails.
- To put out the design for the shingles, start on the backside of the roof and place a tape measure ½ inch from the sting of the roof to make sure the shingles overhang the drip edge.
- Mark 12 inches up on the roof for the primary course of shingles, then mark each 5 inches all the way in which up the roof to set your reveal. Do that on each side of the roof.
- Utilizing the chalk line, snap a straight line on every 5-inch increment.
- Use the chalk line to snap a straight line vertically each 6 inches.
- Set up a starter course by reducing off the three tabs on a shingle, leaving solely the highest tar part.